How to Prime the Pump on a Nespresso
"How do you prime the pump on a Nespresso machine?"
A lot of people have writing in on this, and I have had to look it up myself a few times after forgetting to write it down.
According to Nespresso - the steps are similar for a few machines that I have checked out:
1) Open top lever and push it back as far as it will go for 3 seconds.
2) With the lever still open, press the cup button until water flows.
3) Close the lever and press the cup button to stop the flow of water.
Yes - that was easy. I usually forget to fill up the water and run the pump dry every now and then, maybe you do the same. Not good for a pump to do that too much. Good luck and enjoy.
See My Full Review of the Nespresso Essenza C100
Read More in: Nespresso
Share this Article with others:
Related Articles:
Came straight to this page? Visit Single Serve Espresso for all the latest news.
Posted by Scott Martin at November 5, 2008 8:05 AM
Mailing List
Subscribe - RSS
Site Navigation
